Did a crash or hard landing break your Quad Fighter legs? Replace them with a factory fresh set. This repair requires a very small phillips screw driver (not included).
In stock (can be backordered)
Replacing legs on the Quad Fighter requires a very small phillips screwdriver (not included) to remove the old legs and attach the new replacement legs. Remove the canopy and the four screws from the control board being careful not to damage the control board. Pull the old legs straight down noting the orientation of the battery compartment. Reassemble with the new legs in the same orientation as the old legs to ensure that your battery can reach the power connector on the control board. Make sure the screws are snug being careful not to strip out the plastic hole. If the control board is loose the Quad Fighter will not operate correctly.
|Dimensions||7 x 7 x 3 cm|